Bob Dorough's video: Sand Carving A Flower Mug from Start to Finish

@Sand Carving A Flower Mug from Start to Finish

Oracal 651 cut by a Cricut for a mask. Aluminum oxide 150 grit shot at about 75 psi with a combination of a Harbor Freight benchtop blast cabinet and a Spot Blaster. Kobalt 27 gallon air compressor. Krylon spray paints. Mugs from Amazon.

Bob Dorough

Subscribers
6.6K

Total Post
185

Total Views
5.9M

Avg. Views
117.9K

View Profile

This video was published on 2021-01-30 11:17:14 GMT by @Bob-Dorough on Youtube. Bob Dorough has total 6.6K subscribers on Youtube and has a total of 185 video.This video has received 45 Likes which are lower than the average likes that Bob Dorough gets . @Bob-Dorough receives an average views of 117.9K per video on Youtube.This video has received 8 comments which are lower than the average comments that Bob Dorough gets . Overall the views for this video was lower than the average for the profile.

Bob Dorough's video: Sand Carving A Flower Mug from Start to Finish

Other post by @Bob Dorough