BoostedWhipz's video: Upgraded Puddle Lights with Logo for Tesla Model 3 2017-2022

Installing upgraded "T" and "Tesla" logo puddle lights on the Tesla Model 3 2017-2022 Installation Steps: 1. Use plastic pry tool to remove the OEM standard puddle light. 2. Push on center groove until light harness comes out. 3. Press on power connector release clip and pry open the connector. Remove puddle light. 4. Install new puddle light using the correct orientation. Each puddle light is labeled L for LEFT side and R for RIGHT side. 5. Connect power connector from new puddle light to the power connector of the vehicle. Only fits one way. 6. Check everything lights up and reinsert the light back into the door cavity. Ensure you insert it in the correct orientation. Link used: https://www.amazon.com/dp/B087JNSLT8/ From Vendor: [Upgrade Details] Replace the previous plastic back cover with aluminum parts. increase the heat dissipation area. The pin and plastic parts are integrally injection molded, so the pin is not easily deformed. Adopt four buckle designs to replace the previous two buckle schemes, and reinforce the structure to avoid loosening. [Composition Of Lamp Head] High-transmittance three-layer combination lamp, High light transmission, low energy consumption; A higher-quality laser-etched projection glass (not printed film) for clarity and longevity will be brighter and never fade. [Easy To Install] No drilling, no wiring, no damage to your car. The installation is very simple, and the original door lights can be replaced directly. [Benefits Of Installation] After getting off your Tesla, Puddle Light “T” logo can let the owner see the walking path and avoid water. Open the door of the projection, immediately show your charm, attract more attention, and get praise from friends.