Bruce Whitham's video: 464 Cranky Arm series No 4 Finale

@464 Cranky Arm series No 4 Finale.

The Cranky Arm build is now almost completed Just needs the keyway cut. Time to showcase the project and most of the tools that were used to create the part. I recap the Build requirement and the change made to clamp the arm to the shaft in lieu of the original taper pin fixing system.

bruce s shop machining milling tapping clamping how i resolved the fixing of teh arm to the shaft home machine shop mechanical solutions machine tool lineup gemtrek machine repairs printing press parts let s make it better5. machine part improvements how to measure between two holes alternatives for fixing things to shafts. split clamps

303

Bruce Whitham

Subscribers
9.1K

Total Post
283

Total Views
258.6K

Avg. Views
5.1K

View Profile

This video was published on 2017-08-28 06:46:56 GMT by @Bruce-Whitham on Youtube. Bruce Whitham has total 9.1K subscribers on Youtube and has a total of 283 video.This video has received 303 Likes which are higher than the average likes that Bruce Whitham gets . @Bruce-Whitham receives an average views of 5.1K per video on Youtube.This video has received 33 comments which are higher than the average comments that Bruce Whitham gets . Overall the views for this video was lower than the average for the profile.

Bruce Whitham's video: 464 Cranky Arm series No 4 Finale

Other post by @Bruce Whitham