Bruce Whitham's video: The Jimbo Bridgeport style Mill Controls Upgrade

@The Jimbo Bridgeport style Mill Controls Upgrade

Restarting the Control station upgrade by building one single station panel to replace three seperate small panels. I want to have both mills with the same (as much as possible) control panels and have them both on the same sides, I also want to fit a micro switch to the back gear handle so that when I manually change from high to low the motor controller will have the direction the same.

bridgeport style mills control panel upgrade making controls the same for two mills micro switch on back gear jimbo leads the way 4 axis dro replace 3 with one make it simpler compatability of mill controls bruce s shop improvements home shop machines gert van de merve

293

Bruce Whitham

Subscribers
9.1K

Total Post
283

Total Views
254.6K

Avg. Views
5K

View Profile

This video was published on 2018-04-01 06:07:06 GMT by @Bruce-Whitham on Youtube. Bruce Whitham has total 9.1K subscribers on Youtube and has a total of 283 video.This video has received 293 Likes which are higher than the average likes that Bruce Whitham gets . @Bruce-Whitham receives an average views of 5K per video on Youtube.This video has received 13 comments which are lower than the average comments that Bruce Whitham gets . Overall the views for this video was lower than the average for the profile.

Bruce Whitham's video: The Jimbo Bridgeport style Mill Controls Upgrade

Other post by @Bruce Whitham