Bruce Whitham's video: Machining Mistakes How close can you get to the finish line before you realise UH OH

@Machining Mistakes. How close can you get to the finish line before you realise UH OH!

Almost finished this boring job and realised the setup was not correct. Machining a two part clamp system for a project, that could of added more unwanted issues to the job. We all make mistakes or we hammer away without realising we may be creating a problem down the track. caught it on time.

631

Bruce Whitham

Subscribers
9.1K

Total Post
283

Total Views
237.4K

Avg. Views
4.7K

View Profile

This video was published on 2018-03-12 18:59:12 GMT by @Bruce-Whitham on Youtube. Bruce Whitham has total 9.1K subscribers on Youtube and has a total of 283 video.This video has received 631 Likes which are higher than the average likes that Bruce Whitham gets . @Bruce-Whitham receives an average views of 4.7K per video on Youtube.This video has received 33 comments which are higher than the average comments that Bruce Whitham gets . Overall the views for this video was lower than the average for the profile.

Bruce Whitham's video: Machining Mistakes How close can you get to the finish line before you realise UH OH

Other post by @Bruce Whitham