Dave Hunt's video: DIY PCB Manufacture Toner Transfer Ferric Chloride Liquid Tin

@DIY PCB Manufacture (Toner Transfer, Ferric Chloride, Liquid Tin)

Here's a run through of the method I use for prototype PCBs. That's if I'm too impatient to wait for OSHPark or similar, or if I only need a few single sided boards. This uses photo paper in a laser printer to iron on the design, then Ferric Chloride to etch, and finally Liquid Tin to protect the final copper layer.

Dave Hunt

Subscribers
6.1K

Total Post
68

Total Views
1.8M

Avg. Views
32.1K

View Profile

This video was published on 2020-08-30 23:32:50 GMT by @Dave-Hunt on Youtube. Dave Hunt has total 6.1K subscribers on Youtube and has a total of 68 video.This video has received 19 Likes which are lower than the average likes that Dave Hunt gets . @Dave-Hunt receives an average views of 32.1K per video on Youtube.This video has received 2 comments which are lower than the average comments that Dave Hunt gets . Overall the views for this video was lower than the average for the profile.

Dave Hunt's video: DIY PCB Manufacture Toner Transfer Ferric Chloride Liquid Tin

Other post by @Dave Hunt