Derek Molloy's video: Custom Cables Guide to Crimping Dupont PCB Interconnect Cables

@Custom Cables & Guide to Crimping Dupont PCB Interconnect Cables

This is a very quick video guide to working with custom PCB connectors. I recently had to make a custom connector for my Raspberry PI, which has a bank of male headers. I looked at a few different options and in the end I decided I would invest in a crimp tool to create my own custom cables. While the experiences are still fresh in my mind I decided I would make this video in case that it will be of benefit as an introductory guide to others who are trying to do the same sort of thing. The video will discuss regular ribbon cables, fixed length pre-crimped cables, and custom crimped cables. I will also give a guide to how to crimp 0.1" male and female PCB interconnect cables and describe what a proper crimp connector should look like. See: www.derekmolloy.ie

dcu ireland electronics electronic engineering ee223 dublin city university crimping crimp tool raspberry pi connectors p1 header crimp housing custom cable pololu sparkfun pcb interconnects male female female-female awg housings good crimp crimp guide barrel crimp connector pcb interconnect pi tool custom pre-crimped wire wires derek molloy computer robot gadget technology 0.1 2.54mm 1.27mm 0.05 pcb dupont

3.3K

207

Derek Molloy

Subscribers
53.4K

Total Post
69

Total Views
5.1M

Avg. Views
99.4K

View Profile

This video was published on 2013-04-07 22:22:05 GMT by @Derek-Molloy on Youtube. Derek Molloy has total 53.4K subscribers on Youtube and has a total of 69 video.This video has received 3.3K Likes which are higher than the average likes that Derek Molloy gets . @Derek-Molloy receives an average views of 99.4K per video on Youtube.This video has received 207 comments which are higher than the average comments that Derek Molloy gets . Overall the views for this video was lower than the average for the profile.

Derek Molloy's video: Custom Cables Guide to Crimping Dupont PCB Interconnect Cables

Other post by @Derek Molloy