Derek Molloy's video: The Beaglebone - Unboxing Introduction Tutorial and First Example

@The Beaglebone - Unboxing, Introduction Tutorial and First Example

See www.derekmolloy.ie for my blog and for updates to this video. In this video I introduce the Beaglebone - a low-cost high-performance 720MHz ARM A8 device with 256MB of DDR2 Memory. It has full support for 10/100 Ethernet, USB client support, JTAG debug via USB. It has 64 GPIOs, 7 x 12-bit ADCs, and support for canbus and LCDs. The pin layout is like the arduino where you can place "capes" on the board. The Beaglebone boots using the MicroSD card into embedded Linux (Angstrom). In this video I will demonstrate the first steps with the board and I will discuss how you can use embedded Linux to send or receive values to the input/output pins and the 4 onboard LEDs. This is part of a module on Digital Electronics at the School of Electronic Engineering, Dublin City University, Ireland. www.eeng.dcu.ie/~molloyd/EE223/

beaglebone tutorial introduction intro arm arm a8 embedded linux angstrom dcu dublin city university maker robot unbox unboxing ldr led 1.8v adc beagleboard xm linux embedded mobile device electronics arm architecture computer

Derek Molloy

Subscribers
53.4K

Total Post
69

Total Views
5.1M

Avg. Views
99.4K

View Profile

This video was published on 2012-02-18 06:33:53 GMT by @Derek-Molloy on Youtube. Derek Molloy has total 53.4K subscribers on Youtube and has a total of 69 video.This video has received 1K Likes which are higher than the average likes that Derek Molloy gets . @Derek-Molloy receives an average views of 99.4K per video on Youtube.This video has received 93 comments which are higher than the average comments that Derek Molloy gets . Overall the views for this video was lower than the average for the profile.

Derek Molloy's video: The Beaglebone - Unboxing Introduction Tutorial and First Example

Other post by @Derek Molloy