×

IoTT's video: Controlling LED Signals from JMRI Video 102

@Controlling LED Signals from JMRI (Video#102)
In the last two videos I showed you how to install the RedHat Shield on the Arduino stack and how to configure it, but I only briefly explained how to use the LED chain. So, today I demonstrate how you can use it to add signals to your DCC-EX operated layout and how to drive them from JMRI. If you like my work, please consider supporting it with a donation: https://www.paypal.com/biz/fund?id=Y27LH47B3W354 Tindie page for IoTT Stick, Interface Boards and Function Hats: https://www.tindie.com/stores/tanner87661/ DCC EX information and Downloads: https://dcc-ex.com/index.html MyIoTT.org (landing page under construction): http://myiott.org/ Table of Content 0:00 Start 0:35 What's that pigtail? 1:05 Signaling principle 3:00 JMRI Signal definition 7:05 Signal Aspect setup 9:50 Demo Signal settings 11:22 Neopixel technology 13:45 LED Chain setup 16:40 Signal demonstration 17:30 Summary

0

20
IoTT
Subscribers
3.3K
Total Post
139
Total Views
96.8K
Avg. Views
1.1K
View Profile
This video was published on 2022-09-18 17:30:02 GMT by @IoTT on Youtube. IoTT has total 3.3K subscribers on Youtube and has a total of 139 video.This video has received 0 Likes which are lower than the average likes that IoTT gets . @IoTT receives an average views of 1.1K per video on Youtube.This video has received 20 comments which are higher than the average comments that IoTT gets . Overall the views for this video was lower than the average for the profile.

Other post by @IoTT