MBcreates's video: Rebuilding a large CNC Oxy Fuel Cutter part 2: Installing the new motors

@Rebuilding a large CNC Oxy Fuel Cutter part 2: Installing the new motors

Rebuilding a large CNC Oxy Fuel Cutter part 1: Installing the new motors In the second episode from this CNC oxy-fuel series Maarten and Fons make custom 3d printed and machined connectors to make the new motors fit on the motor units from the oxy fuel cutter. Affiliate links to the products used in this rebuild series: https://bit.ly/Nema34-12Nm https://bit.ly/48v-1000w-supply https://bit.ly/crimp-tool1 https://bit.ly/crimp-connectors https://bit.ly/limit-switches https://bit.ly/E-stop https://bit.ly/nano-v3

MBcreates

Subscribers
19.1K

Total Post
34

Total Views
2.7M

Avg. Views
80.3K

View Profile

This video was published on 2020-05-13 12:09:57 GMT by @MBcreates on Youtube. MBcreates has total 19.1K subscribers on Youtube and has a total of 34 video.This video has received 87 Likes which are lower than the average likes that MBcreates gets . @MBcreates receives an average views of 80.3K per video on Youtube.This video has received 12 comments which are lower than the average comments that MBcreates gets . Overall the views for this video was lower than the average for the profile.

MBcreates's video: Rebuilding a large CNC Oxy Fuel Cutter part 2: Installing the new motors

Other post by @MBcreates