NOSLEEPATALL's video: CNC Plasma Video fail

@CNC Plasma Video fail

This video is about Plasma Video fail along with and actual torch hitting the media on the farthest cut. The main fail would be not turning on the GoPro Hero8 Black when I hit start and had to reach over as the Arclight gantry moved away to start the cut. Second fail was the far left corner of the 1/4 inch steel plate seems to have been high for some reason? This mad the torch touch the plate in the far left cut at the farther end of the plate for some reason? I witness the torch change height to follow the media before and for some reason, it stays at a stationary during this cut sequence? Uses Sheet Cam to make the Gcode with a 65am torch and then Mach3 to run the CNC table. Lastly, the third problem would be the amount of coolant being dumped on the floor but, that I get as it is just being cut to close to the edge of the table for the most part.

hypertherm powermax 105 cnc plasma table cnc machine cnc plasma cutter cnc plasma cutting machine cnc plasma plasma cutting fire pit gopro hero 8 iphone 11 pro max coolant leak arclight plasma table hypertherm plasma cutter gas fire pit cutting quarter inch steel cutting quarter inch fire pit video in video video in video final cut fab work fab shop diy cnc machine cnc machines cnc fails fail video hypertherm powermax 105 powermax

NOSLEEPATALL

Subscribers
4K

Total Post
2.5K

Total Views
89.7K

Avg. Views
1.2K

View Profile

This video was published on 2020-10-02 20:55:31 GMT by @NOSLEEPATALL on Youtube. NOSLEEPATALL has total 4K subscribers on Youtube and has a total of 2.5K video.This video has received 0 Likes which are lower than the average likes that NOSLEEPATALL gets . @NOSLEEPATALL receives an average views of 1.2K per video on Youtube.This video has received 0 comments which are lower than the average comments that NOSLEEPATALL gets . Overall the views for this video was lower than the average for the profile.

NOSLEEPATALL's video: CNC Plasma Video fail

Other post by @NOSLEEPATALL