Neil Underwood's video: Cleaning ABS PLA out of RepRap nozzle using blow torch

@Cleaning ABS/PLA out of RepRap nozzle using blow torch

Yes that is a fireball at the end. I didn't say it was the safest way, just the fastest and most fun. You can also use lye soap to remove PLA, or acetone to remove ABS, but it takes a long time and tends to leave a residue.

reprap

Neil Underwood

Subscribers
2.3K

Total Post
100

Total Views
1M

Avg. Views
19.9K

View Profile

This video was published on 2011-01-02 07:01:01 GMT by @Neil-Underwood on Youtube. Neil Underwood has total 2.3K subscribers on Youtube and has a total of 100 video.This video has received 90 Likes which are higher than the average likes that Neil Underwood gets . @Neil-Underwood receives an average views of 19.9K per video on Youtube.This video has received 40 comments which are higher than the average comments that Neil Underwood gets . Overall the views for this video was lower than the average for the profile.

Neil Underwood's video: Cleaning ABS PLA out of RepRap nozzle using blow torch

Other post by @Neil Underwood