×

RoboCircuits's video: DIY ESP 12 Programmer ESP8266 Programmer

@DIY ESP 12 Programmer | ESP8266 Programmer
DIY ESP 12 Programmer | ESP8266 Programmer How to make an esp 12f/12 or esp8266 programmer. ESP-01 is a low-cost esp8266 module, with built-in WIFI. It was created as an Arduino WIFI module, but It's more powerful than an Arduino, than now if you must do a little module to control a relay or some simple digital datalogger It's the best solution. Exists some variant of this module, but all have a processor L106 32-bit RISC microprocessor core based on the Tensilica Xtensa Diamond Standard 106Micro running at 80 MHz, when you buy one of It you must pay attention only to Flash, some have 512 KiB Flash, other 1MiB Pin Definition VCC: Power 3.0 ~ 3.6V GND: Ground RESET: External reset signal (Low voltage level: Active) CH_PD: Chip Enable. High: On, the chip works properly; Low: Off, a small current GPIO0: (FLASH) I/O General purpose IO, If low while reset/power on takes chip into serial programming mode GPIO1: (TX)I/O General purpose IO and Serial TXd GPIO3: (RX)I/O General purpose IO and Serial RXd GPIO2: I/O General purpose IO and Serial1 TXd

224

24
RoboCircuits
Subscribers
30.1K
Total Post
132
Total Views
1.8M
Avg. Views
20.9K
View Profile
This video was published on 2020-06-18 19:21:44 GMT by @RoboCircuits on Youtube. RoboCircuits has total 30.1K subscribers on Youtube and has a total of 132 video.This video has received 224 Likes which are lower than the average likes that RoboCircuits gets . @RoboCircuits receives an average views of 20.9K per video on Youtube.This video has received 24 comments which are lower than the average comments that RoboCircuits gets . Overall the views for this video was lower than the average for the profile.

Other post by @RoboCircuits