Simon V's video: Upgraded Anet A8 and configurations modifications

Anet A8 with several upgrades : - Extruder's radiator removed - Isolated hot bed - Mosfet for Hot bed and extruder - Z anti-wobble : https://www.thingiverse.com/thing:2502252 - Y chain : https://www.thingiverse.com/thing:2001545 - X chain : https://www.thingiverse.com/thing:1872473 - deported SD card on the top reft - Main power switch on the top right - Bed levelling with inductive 12v sensor (I use a opto isolator in a SD card box) / mount : https://www.thingiverse.com/thing:2319403 - Corner : https://www.thingiverse.com/thing:1999888 (not on this vidéo) - Filament holder : https://www.thingiverse.com/thing:1995043 (not on this vidéo) - 30A power supply (not on this vidéo) Tested Nozzle Fan : Circle : https://www.thingiverse.com/thing:2305368 / good but bad visibility Mistral : https://www.thingiverse.com/thing:2121279 / good (in this video) Semi-circle : https://www.thingiverse.com/thing:2009549 / Very-good successful 36 hours printing test : https://youtu.be/Q5eLbmuIGsQ Running with Marlin 1.1.9 / 1.1.x patched firmware : Configuration.h file : // PID 1/2 PIDTEMP DEFAULT_Kp 33.57 DEFAULT_Ki 3.94 DEFAULT_Kd 71.49 // PID 2/2 PIDTEMPBED DEFAULT_bedKp 278.92 DEFAULT_bedKi 33.06 DEFAULT_bedKd 588.34 // Probe centering (depend of probe and probe support) X_PROBE_OFFSET_FROM_EXTRUDER 77-110 Y_PROBE_OFFSET_FROM_EXTRUDER 110-151 // Extruder centering X_MIN_POS -34 Y_MIN_POS -3 Z_MAX_POS 210 (240 is too much with safe return!) // Bed leveling : useful if bed levelling is active RESTORE_LEVELING_AFTER_G28 // Bed levelling AUTO_BED_LEVELING_BILINEAR // Bed levelling : warning not enough EEPOM memory for 3x3 GRID_MAX_POINTS_X 2 PROBE_BED_POSITION_MARGE 41 LEFT_PROBE_BED_POSITION 0+PROBE_BED_POSITION_MARGE RIGHT_PROBE_BED_POSITION 220-PROBE_BED_POSITION_MARGE FRONT_PROBE_BED_POSITION PROBE_BED_POSITION_MARGE BACK_PROBE_BED_POSITION 220-PROBE_BED_POSITION_MARGE // always level on bed Z_SAFE_HOMING Configuration_adv.h (2 hits) FAN_KICKSTART_TIME 1000 SD_DETECT_INVERTED