The HVAC Hacker's video: Inducer Slurping Water Pressure Switch Ignition Lock Out No Heat Hot Water

@Inducer Slurping Water Pressure Switch & Ignition Lock Out No Heat/ Hot Water

I am on a no-heat service call that I find the heating system locked out on a pressure switch and ignition fault. When I start up the system I hear water slurping around inside the inducer motor. The maintenance guy removed the bottom of the drain trap, yet the boiler was still full of water. I found the drain crusty, gunky, and plugged up where the condensation leaves the combi boiler. I clear the drain and water pours out of the boiler. I clean the drain trap in the sink and reinstall it. The boiler comes on and the condensation correctly drains.

114

The HVAC Hacker

Subscribers
20.4K

Total Post
426

Total Views
215.6K

Avg. Views
4.3K

View Profile

This video was published on 2020-12-23 04:03:53 GMT by @The-HVAC-Hacker on Youtube. The HVAC Hacker has total 20.4K subscribers on Youtube and has a total of 426 video.This video has received 114 Likes which are lower than the average likes that The HVAC Hacker gets . @The-HVAC-Hacker receives an average views of 4.3K per video on Youtube.This video has received 21 comments which are lower than the average comments that The HVAC Hacker gets . Overall the views for this video was lower than the average for the profile.

The HVAC Hacker's video: Inducer Slurping Water Pressure Switch Ignition Lock Out No Heat Hot Water

Other post by @The HVAC Hacker