The Lightning Stalker's video: How to Splice Coaxial Cable Solder

@How to Splice Coaxial Cable (Solder)

Good for receivers and transmitters For transmitters, expect this to work up to about 150MHz. Above that the 1/4" (6mm) area of mismatched dielectric and 1/2" (12mm) of shield could become significant. It can cause reflection and increase SWR. RF weirdness most need not worry about DON'T FORGET TO CHECK OUT MY PATREON! https://www.patreon.com/The_Lightning_Stalker Twitter: @lgtngstk

arrl ham radio antenna coax television solder iron coaxial cable wiring bpbagmbl soldering electronics amateur radio technician general extra fcc cable tv am fm signal rf frequency megahertz mhz

The Lightning Stalker

Subscribers
2K

Total Post
107

Total Views
473.8K

Avg. Views
8.6K

View Profile

This video was published on 2015-06-28 08:36:57 GMT by @The-Lightning-Stalker on Youtube. The Lightning Stalker has total 2K subscribers on Youtube and has a total of 107 video.This video has received 35 Likes which are higher than the average likes that The Lightning Stalker gets . @The-Lightning-Stalker receives an average views of 8.6K per video on Youtube.This video has received 4 comments which are lower than the average comments that The Lightning Stalker gets . Overall the views for this video was lower than the average for the profile.

The Lightning Stalker's video: How to Splice Coaxial Cable Solder

Other post by @The Lightning Stalker