bikebook's video: Stan s Notubes Tubeless System installation

How to install Stans Notubes tire system. Installation Guide: Deflate and dismount the tyre. Remove the inner tube. See the yellow tape; this is the tape that seals the rim toward the spokes. This is Stans rim tape that is required to make rim air tight. Install the valve and tighten the nut. Mount the tyre back on the rim and try to inflate it. If the tyre inflates and stays inflated for a couple of minutes it means you can make tubeless with this combination of rim and tyre. You may need the air compressor for the job but most certainly a big pump. You cannot inflate the tire with small portable pumps. Deflate the tyre and take it off the rim on one small section. Shake the bottle and pour sealant into the tyre. Turn the wheel with open section up and mount the tyre back on the rim. Inflate the tyre. Now shake the wheel and turn it around so the sealant will equally distribute inside and seal all the gaps. Place the wheel on a bucket and wait for a min or two then turn it over. Check for the air bubbles with the soap and water. If you see any shake the wheel some more until the sealant seals the holes.