pygmyboats's video: Construction Tip: How To Snug Panel Ends

@Construction Tip: How To Snug Panel Ends

You might need a few extra wires to help hold your panel tips snug to the ends of the panel above it, especially if you are building a multi-chine hull. If needed, drill a hole right through the boat in the panel above and then loop the wire around the tip which needs secured. Drill the hole roughly ¾" in from the end of the panel and then fold the twist of the wire over the tip and tighten, e.g. if the tips of the panels need to be secured, drill your hole directly through both the left and right panels ¾" in from the panel ends.

#1 #2

pygmyboats

Subscribers
3.2K

Total Post
60

Total Views
1.3M

Avg. Views
25.9K

View Profile

This video was published on 2014-06-25 05:09:19 GMT by @pygmyboats on Youtube. pygmyboats has total 3.2K subscribers on Youtube and has a total of 60 video.This video has received 13 Likes which are lower than the average likes that pygmyboats gets . @pygmyboats receives an average views of 25.9K per video on Youtube.This video has received 0 comments which are lower than the average comments that pygmyboats gets . Overall the views for this video was lower than the average for the profile.pygmyboats #1 #2 has been used frequently in this Post.

pygmyboats's video: Construction Tip: How To Snug Panel Ends

Other post by @pygmyboats